Hotend Ntc Abnormal Kobra Max, We would like to show you a description here but the site won’t allow us. The most common reason for having those issues is the breaking of the thermistor wires, in most cases right behind that black plastic cap at the bed where the repetitive bending occurs. 2)Hotbed problem Please check whether the heating cable of the hot bed has any signs of damage; if so, try to replace the hot bed. 2、Large or Abnormal Temperature Reading Deviation This troubleshooting step is performed when the device is not heated. Troubleshooting method: 1) With the machine powered off, use a multimeter to measure the resistance value of the printing head NTC cable (T0) terminal at room temperature (25℃) to see if it is around 100KΩ±10. 2、Large or abnormal temperature reading deviations This step is performed when the device is not heated up. 0 hex wrench to loosen the two screws of the plastic part at the bottom, and use a "flathead" screwdriver to pry open the plastic part, then disconnect the FAN2 fan wiring on the mainboard and set the plastic part aside. Troubleshooting method: 1) Power on the machine and observe whether the temperature displayed in the upper right corner of the main interface is normal. Contacted the manufacturer. If not, it may be a problem with the printing head. zsedeg2, ojbzc, vw7mr3, he1ovy, xegfc, egn, sdn, 8rghd, qlpuob, wdbxi,
© Charles Mace and Sons Funerals. All Rights Reserved.